Mounting The Utility Sink; Drainage; Supply Lines; Maintenance - Westinghouse QL063 Manuel De L'utilisateur

Armoire de rangement avec évier en acier inoxydable et robinet
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation (continued)

MOUNTING THE UTILITY SINK

Position the cabinet in the intended location . If required, level the cabinet by adjusting
the four leveling legs and checking the alignment of the top using a carpenter's level .
Carefully place a bead of sealant all around the top of the cabinet .
Ease the sink onto the cabinet, and ensure it is placed evenly and centered on the
cabinet . Wipe off any excess sealant . Use masking tape to hold the sink in place until
the sealant dries .

DRAINAGE

The tailpipe (not supplied) previously installed to the drain can now be connected
to your household plumbing . In some cases, your household plumbing will have to
be modified to ensure proper drainage. If so, please consult a licensed plumber to
complete needed modifications.

SUPPLY LINES

Connect the supply lines to your home's water supply as per manufacturer's instructions .
Open the hot and cold water supply valves and check to make sure they have
been installed to appropriate inlet ports . Check for leaks . Run hot and cold water
uninterrupted for about one minute to remove any residue from the lines .

Maintenance

CARTRIDGE REPLACEMENT

- Before proceeding, turn off the water supply to the faucet .
- Take off the plastic temperature indicator by hand, then use the
hex key to remove the setscrew and pull the handle body off .
- Unscrew the cap and retaining ring, making sure not to damage
the threads .
- Pull out the cartridge and replace it with a new 35 mm
(1 .4 in .) ceramic cartridge .
- Reinstall the retaining ring making sure the cartridge is properly
seated within the faucet body .
- Reinstall the cap and tighten gently by hand .
- Reinstall the handle body and lock it in place using the hex key
and the setscrew . Do not over tighten .
- Reinstall the temperature indicator into the handle body making
sure the red is on the left and the blue is on the right .
All manuals and user guides at all-guides.com
9
Please contact cs@conglomkb.com or 1-877-333-0098 for further assistance .
B
A
Temperature indicator
Setscrew
Cap
Retaining ring
Cartridge
Faucet Body
Mastic
Handle
Body
CONGLOMKB .COM

Publicité

Chapitres

Table des Matières
loading

Table des Matières