Westinghouse QL063 Manuel De L'utilisateur page 7

Installation (continued)
FAUCET ASSEMBLY/INSTALLATION
- Carefully take out all the parts of the faucet assembly (C) . The
faucet is pre-assembled, except for the sprayer head .
- Remove the retaining ring, metal washer, and rubber gasket ring
off of the faucet shank .
- Place the faucet shank carefully through the hole in the sink (B) .
A second person may be required to hold the faucet in place
until the installation is complete .
- From underneath, slide the rubber gasket , metal washer, and
retaining ring over the end of the copper pipe and up to the
faucet shank . Tighten the retaining ring by hand until it is snug .
Using a wrench or pliers, tighten the assembly .
- Gently tighten the two screws on the retaining ring .
Do not over tighten .
- Screw the sprayer head onto the flex-neck pipe.
- Attach and hand tighten the supply lines (not supplied) onto
the faucet inlet fittings. Use two wrenches to tighten the two
ends together. Please note, tightening the fittings with a single
wrench may damage the faucet and void the warranty .
NOTE:
It is helpful to have a second person hold the faucet in place while
tightening the mounting nuts. Please ensure that none of the supply lines
are kinked during installation.
All manuals and user guides at all-guides.com
7
Please contact cs@conglomkb.com or 1-877-333-0098 for further assistance .
Gooseneck
Faucet body
Rubber gasket
Retaining ring
Screws
Sprayer
head
Faucet handle
Sink
Metal washer
Threaded shank
CONGLOMKB .COM