Dremel HSES-01 Consignes D'utilisation/De Sécurité page 12

1600A021ET with FCC.qxp_HSES-01 3/27/20 5:18 PM Page 12
4). Stop the tool by releasing pressure
on the tool and the on/off button, align
the electric screwdriver and start again.
Fastening with Screws
The procedure shown in figure 5 will
enable you to fasten materials together
with your Cordless Screwdriver without
stripping, splitting, or separating the
material.
First, clamp the pieces together and drill
the first hole 2/3 the diameter of the
screw. If the material is soft, drill only
2/3 the proper length. If it is hard, drill
the entire length.
Second, unclamp the pieces and drill
the second hole the same diameter as
the screw shank in the first or top piece
of wood.
Third, if a flat head screw is used,
countersink the hole to make the screw
flush with the surface. Then, simply
apply even pressure when driving the
screw. The screw shank clearance hole
in the first piece allows the screw head
to pull the pieces tightly together.
Temperature Dependent
Overload Protection
When using as intended for, the power
tool cannot be subject to overload.
When the load is too high or the
allowable battery temperature is
exceeded, the electronic control
switches off the power tool until the
temperature
temperature range again.
bit holder after the power tool has
automatically switched itself off. Do
not continue to press the On/Off
button after the power tool has
automatically switched off. This can
damage the battery.
Protection against Deep
Discharging
The lithium-ion battery is protected
against deep discharging by the
"Electronic Cell Protection (ECP)".
When the battery is empty, the machine
Operating Instructions
is in the optimum
Do not continue to
apply pressure on the
Fig. 4
Fig. 5
1. Drill 2/3 diameter and
2/3 of screw length for
soft mate rials, full length
for hard materials.
Apply a slight
even pressure
when driving
screws.
is switched off by means of a protective
circuit: The tool no longer rotates.
-12-
2. Drill same
diameter as
screw shank.
3. Countersink
same diameter
as screw head.
Screw