Hooking Up The System - Sony SA-W10 Mode D'emploi

Hooking Up the System

Overview
Use either the INPUT 1 jack or the INPUT 2 terminals
of the woofer when you connect the amplifier.
• If your amplifier has one of the following types of
output jacks, connect the INPUT 1 jack and the
amplifier's jack using the supplied audio connecting
cord.
— MONO OUT jack
— MIX OUT jack
— SUB WOOFER output jack(s)
— SUPER WOOFER output jack(s)
• If your amplifier does not have the above mentioned
output jacks, connect the speaker terminals of the
amplifier to the INPUT 2 terminals instead.
Note
Use either INPUT 1 or INPUT 2 for the connection. Using
both may result in a malfunction.
INPUT1 SPEAKER
SPEAKER
+ R – – L +
INPUT 1
+ – – +
R L
INPUT 2
INPUT2
Before you get started
• Turn off the power of the amplifier and the woofer
before making any connection.
• Use the audio connecting cords that are supplied to
the respective equipment. If there are not enough
audio connecting cords to make the necessary
connections, you need to purchase some optional
audio connecting cords.
• Be sure to make connections firmly to avoid noise.
• Connect the AC power cord from the woofer to a
wall outlet.
• You cannot connect the CENTER output jack for use
with Dolby Pro Logic function to the woofer. Bass
sound is not output with some Dolby Pro Logic
modes.
Getting Started
(continued)
1/04–05_WSA10.11EN 3-810-424-12 (1)
EN
5