Electrolux EFC6422 Mode D'emploi page 10

10
t5
F
Enabling/Disabling the alarm signal
• In Recirculation Version Hoods, the Filter
saturation alarm must be enabled at the
time of installation or later.
• Switch off the lights and the motor.
• Disconnect the mains power supply to the
hood by removing the motor unit power
supply cable connector, switching off the
power supply at the mains or turning the
main switch off.
• Restore the connection, pressing and
holding t2.
• Release the touch control, touch controls
L, t2 and F will light up normally.
• Within 3 seconds press the touch control
F until the key itself flashes to confirm as
follows:
• 2 flashes – Charcoal Filter saturation
alarm EnABLED
• 1 flash - Charcoal Filter saturation
alarm DISABLED
When pressed the motor is set to the
intensive speed timed to 5 minutes. at the
end of 5 minutes of intensive speed the
hood starts again at the speed it was set
to previously. in case the hood is set to the
intensive speed directly from OFF-state it will
then start from the first speed after 5 minutes
of intensive speed.
When pressed for 4 seconds it resets the
filter alarm signal indicated by flashing of
the touch control t1. this procedure can be
carried out only when the motor is stopped.
touch control lit
touch Metal grease filters saturation
control lit alarm. Metal grease filters
need to be washed. the
alarm starts up after 100
working hours.
Flashing Charcoal filter saturation
touch control alarm. Charcoal filter has
to be replaced and metal
grease filters washed. The
alarm starts up after 200
working hours. (activation;
check the paragraph
"Charcoal
liGHtinG
filter")