Scell-it ELEMENT 5 Fiche Technique page 4

● RIVETING:
1- Choose the nosepiece according to the diameter of the
rivet to set. Please refer to the adjacent table to find the
right nosepiece.
CAUTION
the use of the wrong nosepiece can damage the tool.
2 - Place the rivet mandrel into the nosepiece.
3 - Place the rivet body in the hole of the assembling part.
4 - Operate the trigger until the rivet mandrel breaks.
● BATTERY LEVEL INDICATOR:
4 lights on the battery panel allows you to
check the remaining power. Press and hold the
blue button to check the battery level :
4 lights on : 100% remaining
3 lights on : 75% remaining
2 lights on : 50% remaining
1 light on : 25% remaining
The information on the battery panel can vary
(+/- 5%) due to environmental conditions.
Red light on the charger: the
battery has to be charged
MAINTENANCE / TROUBLESHOOTING / SAFETY INFORMATION
See user manual.
OPERATING INSTRUCTIONS
3
5
4
Green light on the charger:
the battery is fully charged
28 rue Paul Dubrule - 59810 LESQUIN - Tél. : 03 20 32 98 18 - technique@scellit.com - www.scellit.com
1
6
NOSEPIECES
Nosepiece Rivet Ø (mm)
A Ø2.4
B Ø3.0/3.2
C Ø4.0
D Ø4.8/5.0
100%
75%
50%
25%
S E R V I C E T E C H N I Q U E
7
2
Trigger
Nosepiece
Mandrel container
Belt hook
Battery
6 Lock / unlock battery
LED lights
7
● REPLAGING NOSEPIECE:
Nosepieces are marked with figures A-B-C-D
linked with rivet diameters.
Use the SW13 key to replace the nosepiece. See user
manual for more details.
● REMOVE THE BATTERY:
Battery is locked to the riveting tool with a spring.
To remove the battery, press the 2 unlock buttons
and slide the battery.
● LED LIGHTS:
ELEMENT FIVE is equipped with 3 powerful LED
lights to enlight the work place.
Turn on the light only
Press the trigger half way to turn on the
light. The lights will shutdown after 10'.
Turn on the tool with the lights on
Press the trigger to set the rivet. The
lights turn on and remain on until 10'
after the trigger is released.
6