Mounting The Transmitter To The Camera; Operating The Devices; Troubleshooting; Maintaining The Device - walser Walimex Pro Excellence Mode D'emploi

Group 3 (3. LED from top must light)
Group 4 (4. LED from top must light)
NOTE
Flash settings can only be made if the settings between transmit-
ter and receiver in the flash unit are matching. The test button on
the transmitter can be actuated at any time and will trigger a flash.

6.2 Mounting the transmitter to the camera

1. Plug the transmitter with its shoe on the
flash socket of your camera.
2. Should your camera not have a hot shoes
contact, you should use the attached
cable to connect the transmitter with your
cameras or the hot shoe.

7. Operating the devices

Press the test button
Before starting work you should check the function of the device and
trigger your flash by pressing the test button on the transmitter.
Flash Power Studio Flash Change
Press the arrow keys (2) to increase
Modeling light on / off
To turn on the modeling light on the studio flash, press the button
for 2 seconds, and press the button for 2 seconds to turn it off.
26
or decrease the flash power.

8. Troubleshooting

Problem Possible cause
Cables not tightly
plugged in
Studio flash switched off
The radio
remote
Different channels/
trigger
groups set between
has no
transmitter and receiver
function
Battery on transmitter
too weak

9. Maintaining the device

9.1. Continuous inspection and maintenance of the device

What you should do
Inspect all cables and plugs for damage
WARNING
If damaged:
Danger of electric shock and danger of fire due to short circuit.
Have the device repaired by an electrician immediately.
Remedy
Plug all cables in tightly
Switch on the studio flash
Make the same
channel-group settings
on both devices, see
channel adjustment
Replace the battery, see
battery replacement
Before each use
X
27