How To Clean Silicone Parts; How To Use The Cleaning Tool - Kuvings M1 Manuel

HOW TO CLEAN SILICONE PARTS

Tip |
Clean the rotation wiper under running water.
Thoroughly dry after cleaning. Before assembling the top-set, ensure that the compression
silicone and silicone ring are fi rmly inserted.
Note | If the compression silicone and silicone ring are not fi rmly inserted, juice may leak from the
bottom of the juicing bowl.
18
Silicone Brush
Pull out the silicone brush from
the rotation wiper to clean.
After cleaning, insert into the slot
with the tail pointing down as
shown in the illustration.
Compression Silicone
Unplug to clean.
After cleaning, fi rmly insert into
the slot below the pulp spout.
Silicone Ring
Remove the silicone ring from the
juicing bowl to clean.
After cleaning, push in the silicone
ring with the smaller surface facing
down.
Smart Cap
Remove from the juice spout
to clean.
After cleaning, attach the smart
cap to the smart cap silicone on
the juice spout.

HOW TO USE THE CLEANING TOOL

* The products illustrated/photographed in this booklet may vary slightly from the actual product.
Tip |
The cleaning tool makes clean-up quick and easy.
Completely dry after cleaning.
Note |
Use the included cleaning brush to remove hard to reach bits after using the cleaning tool.
1 1
Hold the cleaning tool with one hand and insert
the strainer into the cleaning tool.
Note |
Insert the strainer until you hear a click.
2
Under running water, rotate the cleaning
tool and the strainer in opposite directions to
clean.
Thoroughly rinse the inside and outside of
3
the strainer under running water.
4 After cleaning, remove the strainer from the
cleaning tool. Dry before storing.
19