How To Assemble; Operating - Kuvings M1 Manuel

HOW TO ASSEMBLE

STEP 1
Top-set Assembly
Check Before
• Wash the parts before fi rst use.

Operating

• Ensure that the compression silicone and silicone ring are assembled properly.
1 Firmly insert the compression silicone
into the slot below the pulp spout.
Note |
The Juicer may leak if not assembled
properly.
2 Assemble the strainer into the rotation
wiper then place this assembly in to the
juicing bowl ensuring the red dot on
the strainer is aligned with the red dot
on the juicing bowl.
8 8
3 Place the juicing screw into the strainer.
Turn and press down on it until it clicks
into place.
Note |
The juicing screw needs to be locked in
place in order to close the drum lid.
Place the drum lid on to the juicing bowl
4
aligning the red dot on the drum lid
with the red dot on the juicing bowl.
Turn clockwise to close, aligning the red
dot on the drum lid with the close
mark .
STEP 2
Top-set and Base Assembly
5 Place the drum lid on the juicing bowl.
Align the down arrow on the drum lid
with the OPEN mark on the base and
turn to the CLOSE position.
6
Open/Close mark on the top-set.
Open
Close
Note |
Juicer will not operate if parts are not
assembled properly.
7 Place the pulp cup under the pulp spout
and place the juice cup under the juice
spout as shown in the illustration. .
Detachable
Silicone Parts
Silicone parts are washable. Properly
assemble after washing.
• Push in the silicone ring with the smaller
surface facing down.
Tail
• Insert into the slot with the tail pointing
down as shown in the illustration.
9