Starting/Stopping Instructions - Ryobi RGBV3100 Manuel D'utilisation

STARTING INSTRUCTIONS
1. Mix petrol (gasoline) with oil. Fill fuel tank with fuel/oil
mixture. See Oil and Fuel Mixing Instructions on pg. 8.
WARNING: To avoid serious personal injury,
always remove the vacuum bag prior to
refueling the unit. The bag may become a
fire hazard when saturated with fuel.
NOTE: Have the shoulder harness on and adjusted, but
not clipped to the support fitting prior to starting
unit.
NOTE: Fast position is to the right. The throttle lever
will remain in position until moved.
NOTE: Setting the lever to the blower mode prevents
the vacuum bag from filling up while starting the
engine.
NOTE: The ignition switch is a momentary switch and is
always in th ON (I) position (Fig. 10).
2. Set the blower/vacuum mode change-over lever to
the up position (Blower Mode). See Operating as a
Blower, pg. 10.
3. Fully press and release primer bulb slowly 5 to 7
times. Fuel should be felt and visible in the bulb
(Fig. 11). If fuel hasn't entered the bulb, press three
more times, or until it does.
4. Place the choke lever in the FULL choke (A
position (Fig. 11).
5. With the unit on the ground, move the throttle lever
to the fast position (
6. Pull starter rope briskly (Fig. 12). Continue pulling
until the engine sounds as though it wants to run
(normally 2 to 5 pulls).
7. Place the choke lever in the PARTIAL (B
(Fig. 11).
NOTE: The unit will not run in the FULL choke (A)
position.
8. Pull starter rope briskly 1 to 3 times to start the
engine (Fig. 12).
9. If the engine does not start, repeat steps 3
through 6.
Throttle Lever
Ignition Switch
Fig. 10

STARTING/STOPPING INSTRUCTIONS

)
) (Fig. 10).
) position
Idle
Fast
A
10. Allow the engine to warm up for 5 to 10 seconds.
Place the choke lever in the RUN (C
(Fig. 11).
11. Stand in the operating position and clip the shoulder
harness to the support fitting
NOTE: If the engine floods while trying to start, place the
choke lever in the RUN (C
the throttle lever to the fast position (
(Fig 10). Pull the starter rope briskly. The engine
should start with three (3) to eight (8) pulls.
NOTE: Choking is unnecessary when starting a warm
engine. Put the throttle lever in the fast position
(
) (Fig 10) and start unit with the choke lever
in the PARTIAL (B
STOPPING INSTRUCTIONS
1. Move the throttle lever to the idle position (
(Fig. 10). Allow the engine to cool down by
idling.
2. Press and hold the Ignition Switch down in the
STOP [ O ] position until the engine comes to a
complete stop (Fig. 10).
Starter Rope
Fig. 12
B C
Run Position (C)
Partial Position (B)
Full Choke Position (A)
Choke Lever
Primer Bulb
Fig. 11
) position
) position . Move
)
) position (Fig. 11).
)
9