Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT SAFETY INSTRUCTIONS
FOR ALL PRODUCTS:
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings.
Install this apparatus in accordance with the
manufacturer's instructions.
8. Do not install this apparatus near any heat
sources such as radiators, heat registers,
stoves or other apparatus (including
ampli ers that produce heat.
9. Do not defeat the safety purpose of
the polarized or grounding-type plug. A
polarized plug has two blades with one
wider than the other. A grounding-type
plug has two blades and a third grounding
prong. The wide blade or the third prong
is provided for your safety. If the provided
plug does not t into your outlet, consult an
electrician for replacement of the obsolete
outlet.
10. Protect the power cord from being walked
on or pinched, particularly at plugs,
convenience receptacles and the point
where they exit from the apparatus.
11. Use only attachments/accessories
speci ed by the manufacturer.
12. Use only with the cart, stand, tripod,
bracket or table speci ed by the
manufacturer or sold with the
apparatus. When a cart is used,
use caution when moving the cart/
apparatus combination to avoid
injury from tip-over.
13. Unplug this apparatus during lightning
storms or when unused for long periods
of time.
14. Refer all servicing to uali ed service
personnel. Servicing is required when the
apparatus has been damaged in any way,
such as when the power-supply cord or
plug is damaged, liquid has been spilled
or objects have fallen into the apparatus,
or the apparatus has been exposed to rain
or moisture, does not operate normally or
has been dropped.
15. Do not expose this apparatus to dripping
or splashing, and ensure that no objects
lled with liquids, such as vases, are
placed on the apparatus.
16. To disconnect this apparatus from the AC
mains completely, disconnect the power-
supply cord plug from the AC receptacle.
17. The mains plug of the power-supply cord
shall remain readily operable.
18. Do not expose batteries to excessive heat
such as sunshine, re or the like.
CAUTION
RISK OF ELECTRIC SHOCK. DO NOT OPEN.
THE
LIGHTNING
FLASH
ARROWHEAD
SYMBOL,
EQUILATERAL TRIANGLE, IS INTENDED TO
ALERT THE USER TO THE PRESENCE OF
UNINSULATED
"DANGEROUS
WITHIN THE PRODUCT'S ENCLOSURE THAT
MAY BE OF SUFFICIENT MAGNITUDE TO
CONSTITUTE A RISK OF ELECTRIC SHOCK
TO PERSONS.
THE
EXCLAMATION
POINT
EQUILATERAL TRIANGLE IS INTENDED TO
ALERT THE USER TO THE PRESENCE OF
IMPORTANT OPERATING AND MAINTENANCE
(SERVICING
INSTRUCTIONS
LITERATURE ACCOMPANYING THE PRODUCT.
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPARATUS TO RAIN OR MOISTURE.
FCC AND IC STATEMENT FOR
USERS (USA AND CANADA
ONLY)
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions (1 This device may not cause harmful
interference, and (2 this device must accept any
interference received, including interference that
may cause undesired operation.
This Class B digital apparatus complies with
Canadian ICES-003.
Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
FEDERAL COMMUNICATION COMMISSION
INTERFERENCE STATEMENT
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
WITH
AN
and receiver.
WITHIN
AN
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
VOLTAGE"
Consult the dealer or an experienced radio/TV
technician for help.
Caution: Changes or modi cations not expressly
approved by HARMAN could void the user's
authority to operate the equipment.
FOR PRODUCTS THAT TRANSMIT RF
ENERGY:
FCC AND IC INFORMATION FOR USERS
WITHIN
AN
This device complies with Part 15 of the FCC
rules and Industry Canada license-exempt RSS
210. Operation is subject to the following two
IN
THE
conditions: (1 This device may not cause harmful
interference and (2 this device must accept any
interference received, including interference that
may cause undesired operation.
FCC/IC Radiation Exposure Statement
This equipment complies with FCC/IC RSS-
102 radiation exposure limits set forth for an
uncontrolled environment. This equipment should
be installed and operated with minimum distance
20cm between the radiator & your body.
FOR PRODUCTS WITH RADIO
RECEIVERS THAT CAN USE
AN EXTERNAL ANTENNA (USA
ONLY):
CATV (CABLE TV) OR ANTENNA
GROUNDING
If an outside antenna or cable system is connected
to this product, be certain that it is grounded so as
to provide some protection against voltage surges
and static charges. Section 810 of the National
Electrical Code (NEC , ANSI/NFPA No. 70-1984,
provides information with respect to proper
grounding of the mast and supporting structure,
grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors,
location of antenna discharge unit, connection
to grounding electrodes and requirements of the
grounding electrode.
NOTE TO CATV SYSTEM INSTALLER:
This reminder is provided to call the CATV (cable
TV system installer's attention to article 820-40
of the NEC, which provides guidelines for proper
grounding and, in particular, speci es that the
cable ground shall be connected to the grounding
system of the building, as close to the point of
cable entry as possible.
Publicité
