CLAS OC 0215 Mode D'emploi page 8

OC 0215
SPOT WELD AND DENT PULLER
SPECIFICATIONS
• power setting: 10 currents up to 5000A
• thermal protection indicator
• supply voltage: Volt 50-60Hz (AC)-1Phx230
• fuse: 10 amps
• installation power: 1kW
• cadence: 8 to 5 spot/min
• cable length: 3m
• dimensions: 356x105x170mm
• weight: 9.16kg
Composition :
• spot repairer
• SA0239: inertia straightening hammer for spinning
• SA0240: charger for pulling rings
• SA0241: lever of pulling by point + 2 M5 round electrodes (SA0447)
• SA0245: ring/triangles/stars holder electrode
• SA0247: 50 pulling triangles
• SA0248: 50 pulling stars (5 branches)
• SA0249: 50 pulling rings
INSTRUCTIONS
Pulling triangles/stars
Lever of pulling by point
The welding tip must be longer
than the support.
All manuals and user guides at all-guides.com
1. Contact of the
washer with the
workpiece
Polish and clean the welding
tip and screw it in before use.
If the welding tip becomes dull
or black after a long period of
use, please polish it again.
2. Discharge 3. Finishing
arc welding
Press the welding tip before
triggering it on the torch.