Making Ice Cream - ARIETE Sofly Ice Cream 634 Mode D'emploi

MAKING ICE CREAM

- Plug in the appliance and move the switch (A) to "ON" to start the ice cream maker.
IMPORTANT:
The appliance needs to be on and running before the mix is added, to prevent the mix from
freezing immediately inside the container.
Keep the device (I) turned upwards until it is time to dispense.
- Pour the previously prepared and cooled mix into the container (G) through the special opening
(D) in the lid (E).
IMPORTANT:
When filling the container, never go above the "MAX" level marked inside the container; leave
at least 3 cm between the mix and the top of the container (G), since the mix will inflate during
freezing stage.
- Leave the mixing paddle (F) to operate for a maximum of 20 - 30 minutes, until the mix reaches
the right consistency.
IMPORTANT:
Never stop and start the appliance during the freezing process, as the mix could freeze in
contact with the container and prevent the paddle from moving.
For constant, even dispensing, the ice cream needs to remain soft. For this reason, do not
freeze for too long.
- One the ice cream has reached the required consistency, switch off the appliance with the switch
(A) and unplug it from the power mains.
- Position a container in the housing (L) on the base of the appliance body, or lift the cone support
(M) by the tab and insert a standard wafer ice cream cone (Fig. 8).
- Press the dispenser (I) down and proceed to pour the ice cream (Fig. 9). Release the device (I) to
stop dispensing.
- Switch off the appliance, moving the switch (A) to "OFF", at the end of dispensing.
- Keep any remaining ice cream that will not be used up straight away in an airtight freezer con-
tainer.
IMPORTANT:
Never use metal utensils or items inside the container as they could damage the surface, and
do not leave any ice cream inside the container for any length of time (over 30 minutes) to
prevent it from freezing inside.
DISASSEMBLING THE APPLIANCE
IMPORTANT:
When assembling, disassembling or cleaning the appliance, always make sure that it is
switched off and not connected to the mains power.
- With the appliance body raised, press the release button (B) and remove the power base (C) by
pulling it upwards (Fig. 10).
- Remove the lid (E) by turning it anticlockwise.
- Remove the mixer paddle (F).
- 11 -
E N