Cleaning; Disposal; Trouble Shooting - HOLZMANN MASCHINEN ABS 3000SE Mode D'emploi

14.2 Cleaning

After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal surfaces as
well as the use of scrubbing agents will damage the machine surface!
Clean the machine surface with a wet cloth soaked in a mild solution

14.3 Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer
for a replacement unit, the latter is obliged to exchange your old.
15

TROUBLE SHOOTING

BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Machine does not start
Dust emerges from
Loud noise in the fan wheel
housing
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY CONNECTION
TO THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.
HOLZMANN MASCHINEN GmbH
Possible cause
 Switch defective
 Power supply is off
 Fuse is defective
 Electric contactor is defective
 Leaking or blocked connections
 Dust bag or filter bag is defective
or incorrectly installed
 Extracting of a big part
 Loosen fan wheel
www.holzmann-maschinen.at
NOTICE
 Repair switch
 Repair power supply
 Change fuse
 Repair or change electric
contactor
 Check connection
 Remove blockages
 Check bag and filter
 Change defective bag/filter
 Switch of the machine,
disconnect the machine and
remove the part
 Tighten the fan wheel
NOTICE
TROUBLE SHOOTING
Solution
27
ABS 3000SE / ABS 5000SE