Troubleshooting - Panasonic CQ-C300U Manuel D'instructions

Récepteur/lecteur cd avec lecture wma/mp3
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting

If You Suspect Something Wrong
Check and take steps as described below.
If the described suggestions do not solve the problem, it is
recommended to take the unit to your nearest authorized
Panasonic Servicenter. The product should be serviced only by
qualified personnel. Please refer the checking and the repair to
professionals. Panasonic shall not be liable for any accidents
arising out of neglect of checking the unit or your own repair
after your checking.
Never take measures especially those other than indicated by
italic letters in "Possible solution" described below because
those are too dangerous for users to handle themselves.
No power to the unit
Sound is not
generated.
Noise
Noise is made in
step with engine
revolutions.
24
CQ-C300U
Problem
The power cord (battery, power and ground) is connected in the wrong way.
Check the wiring.
Fuse blows out.
Eliminate the cause of fuse blowout and replace the fuse with new one.
Consult your dealer.
MUTE is set to ON.
Set MUTE to OFF.
The wiring of speaker lines are not correct, or a break or poor contact arises.
Check the wiring in accordance with the wiring diagram.
Instructions)
There is an electromagnetic-wave generator such as a cellular phone near the unit
or its electrical lines.
Keep an electromagnetic-wave generator such as a cellular phone away
from the unit and the wiring of the unit. In case that noise cannot be
eliminated due to the wiring harness of the car, consult your dealer.
The contact of the ground lead is poor.
Make sure that the ground lead is connected to an unpainted part of the
chassis securely.
Alternator noise comes from the car.
Change the wiring position of the ground lead.
Mount a noise filter.
Warning
• Do not use the unit in an irregular condition, for example,
without sound, or with smoke or a foul smell, which can
cause ignition or electric shock. Immediately stop using
the unit and consult your dealer.
• Never try to repair the unit by yourself because it is
dangerous to do so.
Possible cause
Possible solution
(
Installation

Publicité

Chapitres

Table des Matières
loading

Table des Matières