Preparation
The demonstration message appears for initial use.
1
Set your car's ignition switch to the
ACC or ON position.
2
Press [PWR] (Power).
3
Hold down [VOL] (PUSH SEL: Select)
for 2 sec. or more to open the menu.
4
Press [VOL] (PUSH SEL: Select) to
select the Demonstration setting.
("DEMO" is displayed)
Preparation Before Initial Use
Pull the insulation film
out from the backside of
remote control gently.
Battery Replacement
Remove the battery
holder with the remote
control unit placed on a
flat surface.
Stick your thumbnail
into the groove, and
push the holder in
the direction of the
arrow, and at the
same time.
Pull it out in the
direction of the
arrow using a tough
pointed object.
Put a battery in the case
with () side facing up.
Put the case back.
The 12-hour system is used for the clock.
1
Press [PWR] (Power).
2
Press [DISP].
3
Hold down [DISP] for 2 sec. or more.
4
Adjust the hour and press [DISP].
[]: Forward
[]: Backward
10
CQ-C300U
Insulation film
Tough pointed object
Back side
5
Turn [VOL] counterclockwise.
For using the remote control, press [0] ().
Notes:
• To return to the regular mode, press [DISP].
• Refer to the section on "Function Setting"
23).
• When "NO DISC" is displayed, the Demonstration
cannot be cancelled.
Warning
Keep batteries and insulation film out of reach of
infants. If an infant ingests a battery, please seek
immediate medical attention.
Cautions
• Remove and dispose of an old battery immediately.
• Do not disassemble, heat or short a battery. Do not
throw a battery into a fire or water.
• Follow local regulations when disposing of a
battery.
• Improper use of a battery may cause overheating,
an explosion or ignition, resulting in injury or a fire.
Notice
This product contains a CR Coin Cell Lithium
Battery which contains Perchlorate Material - special
handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate.
Note: Battery Information:
Battery Type: Panasonic lithium battery (CR2025)
(Included in the remote control)
Battery Life: Approximately 6 months under normal use
(at room temperature)
5
Adjust the minute and press [DISP] to
confirm the adjustment.
[]: Forward
[]: Backward
Notes:
• Adjust the clock when "ADJUST" appears on the display.
• Hold down [] or [] to change numbers
rapidly.
• When "NO DISC" is displayed, the clock cannot be
adjusted.
(
page