Cd Player; Track Selection - Panasonic CQ-C300U Manuel D'instructions

CD Player

Cautions
• This unit does not support 8 cm {3"} discs.
• Do not insert a disc when
because a disc is already loaded.
• Do not use irregularly shaped discs.
• Do not use discs that have a seal or label attached.
• To avoid damaging the face plate, do not push it down or
When a disc is already loaded, press [SOURCE] to
select the CD mode.
1
Press [OPEN] to open the face plate.
2
Load a disc with the printed side facing
up.
Note: It may take some time to start playing.
[] (Eject)
Printed side
3
Close the face plate manually.
Notes:
• The unit recognizes the disc and starts playing
automatically.
• The power will be turned on automatically when a disc
is loaded.
Disc Eject
1 Press [OPEN].
2 Press [] and take the disc out.
3 Close the face plate manually.
Play Mode indicators
Lights when each mode is
activated.
Random play
Repeat play
16
CQ-C300U
• Do not pinch your finger or hand in the face plate.
• Do not insert foreign matter into the disc slots.
indicator lights
• Refer to the section on "Notes on CD/CD Media (CD-ROM,
( page 28)
• A disc which has both CD-DA data and MP3/WMA data on it
Track number
place objects on it while it is open.
CD-R, CD-RW)" ( page 28).
may not be reproduced normally.
4
Select a desired portion.

Track Selection

[] (TRACK): Next track
[] (TRACK): Preceding track (press twice)
Note: Hold down for fast forward/reverse.
Pause
Press [].
Press again to cancel.
Time
Lights when the disc is loaded.