Replacing And Adjusting The Cables; Replacing The Drive Cable; Replacing The Side Brush Lifting Cable; Troubleshooting Table - Nobles SCOUT 7 Manuel De L'opérateur

REPLACING AND ADJUSTING THE CABLES

Replacing the drive cable

To replace the drive cable, proceed as follows:
• Remove the top cowling from the machine.
• Loosen the dowel on the cable locking pin.
• Pull the cable out of the locking pin and completely out of the
drive handle.
To reassemble the cable:
• Insert one end of the cable into the adjustment screw on the
drive handle (the end without the spherical cable lock).
• Insert the cable into the sheath.
• Attach the spherical cable lock to the handle.
•
and then through the cable locking pin.
• Tighten the locking dowel.
To adjust the cable, use the two registers until obtaining the
desired position.

Replacing the side brush lifting cable

To replace the side brush lifting cable, proceed as follows:
• Remove the top cowling from the machine and the front bin.
• Remove the front bumper, the right-side wheel and the right-
side cover.
• Loosen the cable clamp.
•
• Remove the handle from the support and open it.
• Remove the cable from the two sheaths.
To reassemble the cable:
• Place the cable in the handle.
•
• Insert the cables into the sheaths.
• Lock one end of the cable with the clamp and the other end
To adjust the cable, use the two registers until obtaining the
desired position.
EN

TROUBLESHOOTING TABLE

FAULT CAUSE
Belt broken
Gear motor
The centre brush damaged
Wire detached
The side brushes
Belt broken
do not rotate.
No liquid (for lead-
acid battery)
hold its charge
Loose terminal
Dust comes out Filter positioned
of fan incorrectly
Worn gaskets
The brushes wear Brushes pressed
out too quickly too hard
Dust released
when working
Filter clogged
Motor burned out
The suction motor
Wire detached
Battery terminals
detached
The machine
Batteries
discharged
In the event of other malfunctions, contact the
NOTES
dealer

SCRAPPING THE MACHINE

If the machine is to be scrapped, please note that the batter-
ies CANNOT be considered ordinary waste, rather they must
be disposed of in accordance with the laws in force. As the
mended to disassemble it and sort the parts into groups of
the same material, in accordance with the laws in force.
DO NOT USE ANY PART BEING SCRAPPED AS A SPARE
PART. IN THIS CASE TOO, KEEP ALL PARTS OUT OF THE
REACH OF CHILDREN.
- 11 -
TRANSLATION OF ORIGINAL INSTRUCTIONS
SOLUTION
Replace
Contact service
centre
Contact service
centre
Replace
Top up
Tighten.
Replace
Reposition
Replace
Adjust
Replace
Clean
Contact service
centre
Contact service
centre
Check
Recharge
-