Filter Maintenance; Replacing And Adjusting The Side Brush; Replacing And Adjusting The Centre Brush - Nobles SCOUT 7 Manuel De L'opérateur

FILTER MAINTENANCE

rotating brush.
• Remove the rear bin
•
•
running water and allow it to dry completely before replacing
it in the machine.
the whole machine.
performance from your machine. If the sweeper begins to raise
•
Fig. 3 in position "II" for a few seconds. Repeat this operation
while using the machine. This operation should be performed
at the end of every working cycle. If the machine is used
in a dusty environment (e.g. sawmills, warehouses where
more frequently.
•
that all of the functions are deactivated. To do this, turn the
key switch to position "0".
• Remove the rear bin.
•
• Open the handles (pos. 1)
• Turn the catches (pos. 2) 180°
•
•
of more than 20 cm (8 inches).
•
Follow the instructions shown in Fig. 6:
• Remove the rear bin
• Open the handles (pos. 1)
• Turn the catches (pos. 2) 180°
•
•
from the outside to the inside of the machine.
PLEASE CAREFULLY FOLLOW THE REGULATIONS IN FORCE
FOR WASTE DISPOSAL.
2
1
3
Fig. 6
EN
4

REPLACING AND ADJUSTING THE SIDE BRUSH

Replacement
After lifting the front of the machine, to replace the side brush,
brush. Replace it with the new brush and then tighten the screw,
complete with washer.
Adjustment
Turn the front cowling and remove the front bin.
The side brush is adjusted by loosening the screws pos. 1 Fig. 6/A
and manually positioning the brush at the desired height along the
slots. Once having determined the correct height, tighten the two
screws.
Fig. 6/A

REPLACING AND ADJUSTING THE CENTRE BRUSH

Replacement (Fig.6/B)
To replace the centre brush, turn the front cowling and remove
remove the brush. When reassembling the new brush, make sure
the brush is placed in the right direction so as to move the dirt
towards the centre of the machine.
- 9 -
TRANSLATION OF ORIGINAL INSTRUCTIONS
1
Fig. 6/B