Cleaning And Maintenance; Cleaning The Pre-Filter; Cleaning The Particle Sensor - Rabbit Air MinusA2 Manuel D'utilisation

Cleaning and Maintenance

Always unplug the unit before cleaning.
Cleaning the MinusA2
Use a damp cloth to remove stubborn stains and dirty buildup if
necessary. Avoid commercial cleaning products.
1. Use a clean, dry cloth to wipe the external surfaces
of the air purifier. The unit surface should be
cleaned depending on the air quality of the room.
2. Clean the air intake and outlet with a soft brush.
3. Remove the front panel from the unit and use a dry
cloth or soft brush to dust it off.
4. Use a dry cloth, soft brush, or cotton swab to dust
off the Mood Light lens on the back of the panel.

Cleaning the Particle Sensor

Clean particle sensor every three to six months.
Clean the air inlet and outlet using a vacuum
cleaner or soft brush.
1. Open the particle sensor cover on
the right side of the unit (when
facing the unit).
2. Use a damp cotton swab to clean
and dry the lens, dust inlet and dust
outlet.
13
Cleaning the Pre-filter
• Vacuum method:
• Washing method:
outlet air inlet
dust outlet
dust inlet
The Pre-Filter should be cleaned depending on the
air quality of the room.
1. Remove front panel from the air purifier.
2. Run a vacuum cleaner with a nozzle or brush attachment on low
power setting along the Pre-Filter to remove visible particles.
If vacuuming does not seem to sufficiently clean your Pre-Filter,
please follow the steps below to wash it.
1. Remove the Pre-Filter from the unit.
2. Fill the sink with lukewarm water and gently wash the Pre-Filter
under the water for 2-3 minutes or until it is completely clean.
3. Rinse the Pre-Filter with clean tap water.
4. Use a towel to remove any excess water from the Pre-Filter.
5. Allow the Pre-Filter to dry for 12-24 hours.
6. When the Pre-Filter is completely dry, place back into the air purifier.
14