Inspection, Maintenance, And Cleaning - Power Fist 8643413 Manuel D'utilisateur

8643413

INSPECTION, MAINTENANCE, AND CLEANING

WARNING! Make sure the Switch Plate (22) of the 3-SPEED AIR CLEANER is in its "OFF"
position and that the product is unplugged from its electrical outlet before performing any
inspection, maintenance, or cleaning procedures.
1. BEFORE EACH USE, inspect the general condition of the 3-SPEED AIR CLEANER.
Check for loose screws, misalignment or binding of moving parts, cracked or broken
parts, damaged electrical wiring, and any other condition that may affect its safe
operation. If abnormal noise or vibration occurs, have the problem corrected before
further use. Do not use damaged equipment.
2. Periodically, inspect the Filter Net (1) for dirt and debris, and if necessary, remove
and change the Filter Net (1). On the rear of the unit, unlatch the two metal clasps to
release the Filter Net (1). Remove the Filter Net (1) and inspect it to see whether it
needs a simple cleaning, or it needs replacement. Reinsert a Filter Net (1) (old or new)
and lock it in place with the two clasps. (See FIGURE 3).
Note: During this procedure, wear ANSI approved safety goggles and dust protection.
3. Periodically, inspect the Inner Filter (2) for dirt and debris, and if necessary, remove
and change the Inner Filter (2). On the rear of the unit, unlatch the two metal clasps to
release the Filter Net (1). Remove the Filter Net (1). Then, remove the Inner Filter (2)
and inspect it. If necessary, use compressed air to blow dirt and debris from the Inner
Filter (2). Replace the Inner Filter (2) and the Filter Net (1) in the rear of the unit and
lock them in place with the two clasps. (See FIGURE 3).
Visit www.princessauto.com for more information
1,044 CFM Air Cleaner
Inner Filter (2)
Filter Net (1)
FIG. 3
V4.0
9