Wiring Diagram - Power Fist 8643413 Manuel D'utilisateur

V4.0
TROUBLESHOOTING
Note: Any repairs suggested below should be completed by an authorized service technician.
Trouble
Motor does not run
when power switch is
pressed on.
Motor does not run at
full speed.
Motor will not reach
full power.
Motor overheats.
Insufficient suction
power.
Unit is shaking.

WIRING DIAGRAM

10
1,044 CFM Air Cleaner
Probable Cause
1. Blown fuse.
2. Switch is burned out.
3. Connection wire is loose or
damaged.
1. Power voltage is too low.
2. Motor is damaged.
1. Incorrect power wiring.
2. Overload.
1. Using wrong voltage.
2. Motor is damaged.
1. Inlet port blocked.
2. Filter Bag is full.
3. Outlet port blocked.
1. The unit isn't properly
anchored.
2. The unit isn't level.
3. Worn or damaged power
cord.
control panel
1. Replace fuse.
2. Replace the Switch.
3. Tighten or replace the wire.
1. Test voltage.
2. Check and repair motor.
1. Replace incorrect power
wiring.
2. Reduce load by cleaning
filters as necessary.
1. Check voltage and voltage
label.
2. Check and repair the Motor.
1. Clean inlet port.
2. Empty Filter Bag.
3. Clean the outlet port or
adjust the direction of the
outlet.
1. Mount the unit firmly.
2. Level the unit.
3. Repair or replace power
cord.
MOTOR
For technical questions call 1-800-665-8685
8643413
Correction