Maintenance - Sears Craftsman 919.679470 Guide De L'utilisateur

• On the engine there is a choke/run lever. Place this
lever to the choke position.
• Grasp the starter handle and pull rope out slowly
until it pulls harder. Let the rope rewind slowly.
Then pull rope with a rapid full arm stroke. Let rope
return to starter slowly.
• When engine starts, gradually move choke lever to
"Choke Position".
• If the engine fails to start after (3) pulls, move the
choke lever to the beginning choke position and pull
start rope again.
• For hot engine starts make sure choke lever is in the
choke position.
Connecting Electrical Loads
• Let engine run and warm up for about five minutes
after starting.
CUSTOMER RESPONSIBILITIES TABLE
MAINTENANCE TASK
Check oil level
Change oil
Clean Air Filter Assembly
Check Spark Plug
Prepare Unit for Storage
Note 1: Change oil after first two (2) operating hours and every 50 operating hours thereafter, more often if operated in
extreme dusty or dirty conditions.
Note 2: Check oil after 5 hours of operation (See page 13 - Oil Maintenance.)
All manuals and user guides at all-guides.com

MAINTENANCE

Every 25
Before each Hours of
use Every
Season
X See Note 2
Prepare unit for storage if it is to remain idle for more than 30 days.
12 — ENG
• Plug in the desired 120 or 240 volts tools.
• DO NOT connect 240 volt equipment to the 120 volt
duplex receptacles.
• DO NOT connect 3-phase loads to the panel
receptacles.
IMPORTANT: You should always add up the rated
watts of all lights, tools and appliances you are power-
ing at one time. This total should not exceed the rated
capacity of your generator or circuit breaker rating of
the receptacle supplying power.
Stopping The Engine
• Disconnect all electrical loads.
• Switch the start/off switch to the off position.
STOP
IMPORTANT: Never store engine with fuel in tank ,
indoors, or in enclosed, poorly ventilated areas or where
fuel fumes may reach an open flame.
Every 50 Hours
of Every
Season
See Note 1
X
X
ON
Every 100 Hours of
Every Season
X