Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4a. The steam gun (2) is equipped with a safety switch (2A)
which prevents the accidental start of the steam jet by
children or people who do not know how to operate the
appliance. With the switch 2A in the "OFF" position, the
lever controlling the steam jet is locked. Should the
hose be left unattended for a moment whilst the appli-
ance is connected to the mains, it is recommended to
put the safety switch in the "OFF" position.
To start the steam jet, move the 2A switch backwards (ON) and activate the steam
request lever (fig. 4). The first burst of steam may contain some water droplets, due
to imperfect thermic stabilisation inside the flexible hose. We would therefore advise
that the first jet of steam is played onto an old cloth until a constant pressure of steam
is obtained. Should the hose be submitted to an excessive torsion during the use, the
No-Volt device will stop the steam flux. In order to restore the output, just press the
steam request lever.
Note: The on/off switch (B) may go on and off from time to time during use of
VAPORETTO. This indicates the machine maintaining the correct and constant pressure
and is quite normal.
C
O
C
To connect the accessories tools to the hand gun proceed
as follows (Fig. 6)
1b. Move the connector button (11) on the accessory to the
"open" position.
2b. Attach the required tool to the hand gun.
3b. Move the connector button (11) back to the position
'closed'
4b. Check that the connector button has engaged and the
accessory is fully connected.
ENGLISH
N
N
E
C
T
I
O
N
O
F
O
N
N
E
C
T
I
O
N
O
F
Fig. 4
A
C
C
E
S
S
O
R
I
E
S
A
C
C
E
S
S
O
R
I
E
S
Fig. 6
Publicité
Table des Matières
