Maintenance Schedule - Cub Cadet CC 2000 Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operation (continued)
Fig. 5-6
Section 6
Maintenance
NOTE: Some maintenance procedures may require
special tools or skills. If you are unsure about these
procedures take your unit to an authorized service
dealer.

MAINTENANCE SCHEDULE

These required maintenance procedures should be
performed at the frequency stated in the table. They
should also be included as part of any seasonal tune-up.
WHEN
Before Starting Engine
Every 10 Hours
Every 25 Hours
Bolt
Fig. 6-1
12
MAINTENANCE NEEDED
Fill fuel tank with correct oil and fuel mixture.
Clean and re-oil air filter.
Check spark arrestor and clean
Check spark plug condition and gap
Bump Knob
DECORATIVE TRIMMING
Decorative trimming is accomplished by removing all
vegetation around trees, posts, fences, etc.
Rotate the whole unit so that the cutting attachment is
at a 30° angle to the ground (Fig. 5-6).
To prevent serious injury, never do maintenance
or repairs with unit running. Always do
maintenance and repairs on a cool unit.
Disconnect spark plug wire to ensure the unit will
not start.
LINE INSTALLATION
This section covers both Membrane line and standard
single line installation.
Always use manufacturer's 0.095 inch (2.41 mm)
replacement line. Using line other than specified may
make the engine overheat or fail.
Never use metal-reinforced line, wire, chain, or
rope, etc. These can break off and become
dangerous projectiles.
GO TO:
Page 9
Page 15
Page 15
Page 17

Publicité

Table des Matières
loading

Table des Matières