CHICAGO Electric 97907 Installation Et Instructions D'utilisation page 14

problem
Tool will not start
Tool operates
slowly or
intermittently
Chuck will not turn Direction Button of Trigger may
Drill bit slips in
chuck
Follow all safety precautions whenever diagnosing or servicing the
tool. Disconnect power supply before service.
please reaD tHe FOllOWing careFully
THE MANUfACTURER AND/OR DISTRIbUTOR HAS PROvIDED THE PARTS LIST AND ASSEMbLy
DIAGRAM IN THIS MANUAL AS A REfERENCE TOOL ONLy. NEITHER THE MANUfACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS qUALIfIED TO MAkE ANy REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
qUALIfIED TO REPLACE ANy PARTS Of THE PRODUCT. IN fACT, THE MANUfACTURER AND/
OR DISTRIbUTOR ExPRESSLy STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD
bE UNDERTAkEN by CERTIfIED AND LICENSED TECHNICIANS, AND NOT by THE bUyER. THE
bUyER ASSUMES ALL RISk AND LIAbILITy ARISING OUT Of HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT Of HIS OR HER
INSTALLATION Of REPLACEMENT PARTS THERETO.
SKU 97907
troubleshooting
possible causes
1. No power at outlet.
2. Cord not connected.
3. Cord Damaged
4. Carbon Brushes worn or
damaged
Worn or damaged Carbon
Brushes
be in middle position.
1. Jaws are loose
2. Bit is jammed in work piece
For technical questions, please call 1-800-444-3353.
possible solutions
1. Check power at outlet.
2. Check that cord is plugged in.
3. Check condition of cord
4. Check condition of Carbon Brushes, replace
if necessary.
Check condition of Carbon Brushes, replace if
necessary.
Press Direction Button fully to left or right.
1. Tighten chuck
2. Tighten chuck, then operate tool in reverse
to back bit out of work piece.
Page 14