Publicité
Les langues disponibles
Les langues disponibles
The IL0010 remote indicator is specially designed and manufactured for use with coventional
detectors from the IRIS series or addressable detectors from the ENEA series, when it is required
the remote replication of the detectors signal without additional devices.
The remote indicator, placed near the detector protected area, allows the early identification of
alarm condition.
Using a high efficiency LED warning light and a lens allows low consuption and wide coverage.
The remote indicator can be wall or ceiling mounted.
In case of detectors without current limitation, the jumper [D] must be removed (cut).
Housing backplate
A
B
C
Terminal board
Current limitation jumper
D
Detector mounting base
E
TERMINALS
to be connected with:
Addressable detector (ENEA)
+ A
Conventional detector (IRIS)
+ C
-
Detector "R" terminal
TECHNICAL SPECIFICATIONS
Power supply
Average current draw in
alarm
Housing material
IP rating
Operating temperature
Humidity
(without condensation)
Dimensions (WxHxD)
Weight
INIM Electronics reserves the right to
change the technical specifications of this
product without prior notice.
IL0010
Remote indicator
PCB
positive terminal
positive terminal
19-30 Vdc
20 mA @27,6V
ABS
IP42
-5°C/+40°C
95% RH
79x76x27 mm
45 g
A
B
D
C
E
INIM Electronics s.r.l.
via Dei Lavoratori 10, Centobuchi
63076, Monteprandone, (AP) Italy
Tel. +39 0735 70 50 07
Fax + 39 0735 70 49 12
www.inim.biz info@inim.biz
2
Publicité
