General; About This Document; Safety; Personnel Qualification - Dimplex UP 75-25PK Instructions D'installation Et D'utilisation

English
1

General

1.1 About this document

The installation and operating instructions are part of the product.
They must always be available close to the product. These in-
structions must be observed to ensure that the device is used
and operated as intended.
2

Safety

These operating instructions contain basic notes which must be
observed during installation and operation. It is therefore essen-
tial for the technician and the operator to read these operating in-
structions before the product is installed and started up.

2.1 Personnel qualification

Any personnel involved in the installation must be qualified to
carry out this kind of work.

2.2 Danger in case of non-observance of the safety information

Persons and/or the pump/system are at risk if the safety notes
are not observed.

2.3 Safety notes for the operator

Observe the valid accident prevention regulations.
It must be ensured that there are no risks resulting from electrical
energy. Instructions resulting from local or general regulations

2.4 Safety notes for inspection and installation work

The operator must ensure that all inspection and installation work
is carried out by authorised and qualified specialists who have
studied the operating instructions in detail.

2.5 Impermissible operating modes

The operating safety of the pump supplied can only be ensured if
the pump is properly used according to Kap. 4 auf S. 3 of the op-
3

Transport and intermediate storage

ATTENTION!
Danger of damage to the pump
Danger of damage due to improper handling during transport and
storage.
The pump must be protected against humidity, frost and mechanical
damage during transport and intermediate storage.
EN-2
All manuals and user guides at all-guides.com
Not only the safety information listed here under Safety must be
observed, but also the special safety information listed under the
other sections and marked with safety notes.
(e.g. IEC, VDE etc.) and from local utility companies must be ob-
served.
Work on the pump/system must only be carried out when the
pump/system is not operating.
Unauthorised alterations and the manufacture of spare parts are
not permitted.
erating instructions. The limit values stated in the catalogue/on
the data sheet must never be undershot/exceeded.
452115.66.53 · FD 9712
UP 75-25PK - UP 75-32PK