Table des Matières
Publicité
ENGLISH
PARTS
1. On/off switch
2. Main blade
3. Vacuum intake
4. Vacuum chamber
5. Vacuum chamber release buttons
6. Detail blade
7. Adjustable beard comb 2 – 18mm
CHARGING
Charge the device:
•
Before using for the first time.
•
When the charge indicator light is flashing.
•
After it has not been used for a long time.
1. Ensure the product is switched off.
2. Connect the product to the adaptor and then to the mains.
3. When charging, the charge indicator light will light up. The light will go out when
charging is complete.
4. A first time charge should take approximately 2-4 hours. Top up charges should take
approximately 2 hours.
•
To preserve the life of your batteries, let them run out every 6 months then fully charge.
CORDED/CORDLESS USE
•
When fully charged, your trimmer should provide approximately 60 minutes of cordless
use.
•
You can also connect the charger (as if you were going to charge the trimmer) and
operate the trimmer 'corded' if desired.
ATTACHMENTS
EXCHANGING THE MAIN AND DETAIL BLADES
Your trimmer is supplied with the main blade already fitted. It is easier to remove and refit
the main blade with the vacuum chamber removed.
1. Switch your trimmer off.
2. Hold the trimmer in one hand.
3. Push the top of the blade away from the trimmer body using your thumb (Fig A)
4. Use enough force to free the blade from the trimmer body. Once free, lift it off.
5. Fit the desired blade by engaging the tab on the back of the blade into the rear of your
trimmer. Press the front of the blade down until it clicks.
6. Replace the vacuum chamber.
4
8. Charge indicator light
9. Charger connector
10. Comb lock button
11. Charging adapter (not shown)
12. Storage case (not shown)
13. Cleaning brush (not shown)
Publicité
Table des Matières
