Brandson 304416 Mode D'emploi page 24

6. ECO mode
The default setting of the temperature in this mode is 24°C when the ECO energy
saving mode is selected. Based on the current temperature and the target tem-
perature of 24°C, the heater automatically selects the heating level to reach the
target temperature.
7. Remote control
Use 2x 1,5V AAA batteries for the remote control. All the functions that can be
performed using the remote control have the identical function as those on the
control panel of the fan.
8. Oscillation
To turn the oscillation on or off, press the "Oscillation" button on the control panel
at the top of the fan or on the remote control.
9. Timer function
You can enable the timer function by pressing the "Timer" button. The currently
configured timer stage is displayed.
10. Tilt protection
Thanks to the tilt protection at the bottom of the heater, it switches off automat-
ically if the appliance tilts over. Please place the appliance only on even and flat
surfaces.
11. Overheating
WARNING: The heater should not be covered to avoid overheating.
Overheating generally occurs only if one of the openings of the fan heater is cov-
ered, blocked or clogged. This appliance has overheating protection. The heater
switches off automatically once the overheating temperature is reached. If the ap-
pliance is therefore turned off for this reason, disconnect the plug and wait for 30
minutes. Then try to switch it on again. Please contact customer service if this does
not happen. After switching off the appliance, the fan continues to run in cooling
phase until it completely shuts down.
12. Cleaning and maintenance
Disconnect the product from the power supply before cleaning or maintenance.
Do not use any aggressive or chemical cleaning agents. Use a dry, soft cloth.
Ensure that you do not touch the heater elements when cleaning!
24
English