Brandson 304416 Mode D'emploi page 23

Operating
controls
Oscillation On/Off
5. Initial use
Take the appliance out of the package and remove all the packaging material. Place
the fan heater on a level and flat surface so that the tilt protection at the bottom is
not actuated. Connect the appliance to a 220-240V AC socket.
To start the fan heater, press the "Power" button on the control panel or on the
remote control. The fan heater now starts to heat. Press the "Temperature" button
to adjust the desired temperature. The display shows the set temperature above
the button on the fan heater. The heater will start heating if the set temperature is
higher than the room temperature. The fan heater has 3 heating modes.
English
Mode button
Timer On / Off
ECO mode
Heat setting 1
Heat setting 2
You can navigate through the different heating modes by
pressing the "Mode" button.
Eco-Mode
Power
button
Temperature
button
23