sunjoe TJW24C Manuel De L'opérateur page 13

m
WARNING!
Unexpected blade movement may cause
personal injury. Before servicing, repairing, or inspecting the
unit, turn the motor OFF and remove the battery.
Wait for the blade to completely stop rotating before
conducting inspection, cleaning, or maintenance.
Before and after each use, check the product and accessories
(or attachments) for wear and damage. When necessary,
only use identical replacement parts that are approved by the
manufacturer.
IMPORTANT!
• Wear protective gloves when cleaning or maintaining the
machine.
• Do not use cleaning fluids or solvents or spray the
machine down with water (especially water under
pressure) when cleaning the machine.
NOTE: After each use, follow these steps to properly clean the
unit:
1. Remove soil, dirt, and foliage stuck in the blade, drive
shaft, tool surface, and vents with a brush or dry cloth.
2. Spray or rub biodegradable oil onto the blade.
3. Clean soiled grips with a damp cloth.
Always inspect the machine for damaged and worn parts after
each use. Check that safety features (i.e. labels, guards, etc.)
are in place. Check that nuts, bolts, and screws are tight.
Replace the Tilling Blade
The machine is fitted with a 10 tine steel tilling blade that can
easily be changed. Only use the original replacement part
specified for this cultivator + weeder.
You can purchase a replacement blade (Model
TJW24C-BLADE) and other genuine replacement parts by
visiting us online at sunjoe.com or calling our toll-free customer
service helpline at 1-866-SNOWJOE
(1-866-766-9563). The use of parts that do not meet the
original equipment specifications may lead to improper
performance of the cultivator + weeder, may compromise
operator safety and will void the manufacturer's warranty.
m
WARNING!
The tilling blade is sharp and can cause
severe personal injury if handled incorrectly. Wrap the blade or
wear protective gloves, and use extra caution when handling.
To replace the tines, follow the steps below:
1. Turn off the unit, remove the battery and wait until the
blade has come to a standstill.
2. Using the provided wrench, remove the nut and the
washer used to fix the tilling blade from the motor shaft,
then remove the old blade from the motor shaft (Fig. 12).
Fig. 12
Steel blade
Motor shaft
Cultivator + weeder head
3. Insert the new steel blade on the motor shaft. Make sure
to align the notches on the blade hole with the notches on
the motor shaft, and press the blade firmly on the motor
shaft until it sits flush (Fig. 13).
Fig. 13
Notches on the shaft
Note: Failure to align the notches will cause the blade to be
unstable and wobble during use.
4. Reassemble the washer and the nut to fix the blade.
Use the wrench provided to secure the nut tightly. Insert
the battery and resume working.
Repair
This product does not contain any parts that can be repaired
by the consumer. Contact an authorized
Snow Joe + Sun Joe dealer or call the
® ®
Snow Joe + Sun Joe customer service center at
® ®
1-866-SNOWJOE (1-866-766-9563) for assistance.
Storage
• Examine the cordless cultivator + weeder thoroughly for
worn, loose, or damaged parts. Should you need
to repair or replace a part, contact an authorized
Snow Joe + Sun Joe
®
+ Sun Joe customer service center at 1-866-SNOWJOE
®
(1-866-766-9563) for assistance.
13
Nut
Washer
Notches on
the blade
hole
Steel blade
Motor shaft
dealer or call the Snow Joe
® ®