3. To disassemble the cultivator + weeder head from the pole
assembly, unlock the cultivator + weeder head lock,
then press in the releasing tabs on each side, and at the
same time pull the cultivator + weeder head out from the
pole assembly (Fig. 5).
Fig. 5
Cultivator +
weeder head
lock
Cultivator +
weeder head
Operation
Intended Use
The TJW24C cordless mini cultivator + weeder is designed
for small gardens and flower beds, this cordless cultivator +
weeder effectively loosens and turns over new soil. It may also
be used to mix coarse soil with fertilizer, peat, and compost.
This product may not be used to till extremely dry or wet soil.
The use of this product in rain or wet conditions is prohibited.
For safety reasons, it is essential to read the entire instruction
manual before first use and to observe all the instructions
contained within this manual.
This product is intended for private domestic use only. It is not
intended for any commercial trade use. It must not be used for
any purposes other than those described.
Telescoping Pole Adjustment
m
WARNING!
Always switch the product off and remove
the battery before making any adjustments.
This product is equipped with a telescoping pole that can be
adjusted. To adjust the pole, follow the instructions below.
1. Unlock the telescoping pole by turning the telescoping
lock clockwise. Extend the pole to the desired length
(Fig. 6).
Releasing tabs
PULL OUT
NOTE: Push poles toward each other to shorten the pole
or pull them away from each other to lengthen the pole.
Only extend the pole to the minimum length required to
reach the ground.
Fig. 6
Telescoping lock
2. Lock the telescoping pole in position by turning the
telescoping lock counterclockwise, and ensure that the
pole is secured.
m
WARNING!
Always ensure the telescoping pole is
securely locked. Do not attempt to use the product with the
pole unlocked.
Auxiliary Handle Adjustment
m
WARNING!
Always switch the product off and remove
the battery before making any adjustments.
NOTE: For maximum comfort and control, adjust the auxiliary
handle to fit your height. Shorter users adjust the auxiliary
handle to a lower position (away from your body). Taller users
adjust the auxiliary handle to an upper position (towards to
your body). Make sure your forearm is straight when using the
machine.
1. Loosen the auxiliary handle by turning the handle knob
counterclockwise (Fig. 7).
Fig. 7
Handle knob
10
Telescoping pole
Auxiliary handle