Operation; Care And Cleaning - BASETech 812537 Notice D'emploi

All manuals and user guides at all-guides.com

8. Operation

• Make sure that the product is turned off. The switch must be in the middle position O.
• Connect the mains plug to a standard mains socket.
• Select a nozzle that is suited for the application at hand. Place the nozzle on the air outlet.
• Use the switch to set the power level which will adjust the temperature and air flow.
Switch position
Press down
In the middle
Press up
• The product is suitable for both manual operation and stationary operation.
Manual operation:
Grasp the handle so that you can operate the switch with your index finger.
Stationary operation:
Place the product in an upright position on the rear stand and lower part of the handle.
Make sure that the surface is dry and free from grease and dust. Otherwise, polluted air may be sucked into the
inside of the product. This may damage the motor.
• The shape of the nozzle, the distance to the object and the power level depend on the material and the desired
processing mode. Perform a test before beginning the job at hand.

9. Care and cleaning

Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these could damage the
casing or stop the product from functioning properly.
• Disconnect the product from the power supply before cleaning and let it cool down sufficiently.
• Do not immerse the product in water.
• Use a dry, lint-free cloth to clean the product. To remove stubborn dirt, moisten the cloth slightly with lukewarm
water.
• Use a soft, dry brush to clean the ventilation openings.
16
Stage 3 Temperature
I 300 °C
O
II 600 °C
Power Air flow
1000 W 500 l/min
Switched off
2000 W 650 l/min