Foppapedretti Playgio Instructions De Montage page 13

1
2
3
1
A
• ENGLISH •
All manuals and user guides at all-guides.com
ASSEMBLY
"click"
"click"
Internal side
A
A
PRE-ASSEMBLY OF FRAME SUPPORT BRACKETS
Rotate one side of the bracket outwards (fig.1) until you hear
a click, indicating that it is locked correctly (fig.2). Repeat this
process with the other brackets.
ASSEMBLING THE SUPPORT BRACKETS IN THE
TOP UPPER FRAME
Place the upper frame upside down on the floor. To
protect the frame, place a cloth on the floor.
Insert the top part of the support brackets into the
appropriate slots in the frame, as shown in the diagram.
To do this, insert the support brackets into their
respective slots by pressing gently. A click will indicate
that the bracket has been correctly inserted and locked
to the frame. Make sure that all three brackets are
correctly inserted and attached to the frame before
continuing with the assembly.
MOUNTING THE UPPER FRAME ON THE
BASE
Place the base on the floor.
Insert the lower end of the support brackets
into their respective slots, as shown in the figure
(1).
To complete the assembly, press the "A" button
and push the bracket downwards until it locks in
position 1, 2 or 3. A click will indicate that it has
locked correctly. Repeat this process with the
remaining two brackets.
To adjust the height of the seat, press the
"A" button and raise or lower the connection
bracket until the button itself locks in the
desired position, 2 or 3.
IMPORTANT: The three brackets must always
be adjusted all in the same position: 1, 2 or 3.
A
13