Eu Declaration Of Conformity; Responsibilities Of The User - ABIKOR BINZEL ROBO WH Série Mode D'emploi

WH and WHPP
1 Identification

1.1 EU Declaration of Conformity

Designation
Relevant EC Directives
Harmonized standard applied
Tab. 1 EU Declaration of Conformity

1.2 Responsibilities of the User

The Welding torch system WH/WHPP is used in industry and in the trade for
inert gas welding using inert gases (MIG) or active gases (MAG). It allows the
torch neck to be easily changed either manually or automatically. The
automatic change is done in connection with the ATS rotor. This series can be
used in all welding positions. Depending on the model, the welding torch is
either air- or liquid-cooled. The liquid-cooled model requires a re-circulating
cooling unit. These operating instructions only describe the Welding torch
system WH/WHPP. The welding torch system may only be operated with
original ABICOR BINZEL spare parts.
according to EC Low Voltage Directive 06/95/EC, Annex III.
We,
Alexander Binzel Schweisstechnik GmbH & Co. KG
Legal representative of the documentation: Hubert Metzger
Kiesacker 7-9, 35418 Alten-Buseck
hereby declare that, on the basis of its design and construction, the Welding
torch system WH/WHPPdescribed in these operating instructions complies
with the basic safety and health requirements of the EC directive. Any
modification not agreed with us will void this declaration.
Welding torch system WH, WHPP
EC Low Voltage Directive 06/95/EC, Annex III
DIN EN 60 9747 Part 7
Within the EEA (European Economic Area) the current version of the national
implementation of the Framework Directive (89/391/EEC) and the related
individual directives and, of these, especially Directive (89/655/EEC)
concerning the minimum safety and health requirements for the use of work
equipment by workers at work must be adhered to. In Germany, the Job
Protection Law and the Company Safety Ordinance must be heeded.
In addition, the operator must ensure that the welding torch and welding unit
comply with the EC EMC Directive (89/336/EEC) and that the signal
utilization of the integrated welding current monitoring against stray currents is
installed properly.
1 Identification
EN - 3