Dynex DX-CRD12 Guide De L'utilisateur page 7

Installing the card reader
Pin
P2
P1
System board connector
Caution: Electrostatic discharge (static electricity) can damage electronic components. Make
sure that you are correctly grounded before you install your card reader. Turn off your
computer, then touch a bare metal part of your computer, such as the back of the chassis
or power supply, to discharge any static electricity.
To install your card reader:
1 If you are installing your card reader into a computer running Windows 98SE, install
the driver before installing your card reader. For more information, see "Windows 98SE
and Windows ME" on page 9.
2 Make sure that you are correctly grounded by touching a bare metal part of your
computer, such as the back of the chassis or power supply.
3 Turn off your computer and disconnect the power cord.
4 Open your computer's cover. For more information, see the documentation that came
with your computer.
5 Make sure that your computer's system board corrector is compatible with your card
reader' s USB connector. For more information, see "USB pin cable assignment" on
page 6.
6 Carefully slide your card reader into the empty drive bay.
Cable color
White D–
Red VBUS
Function
7