Audizio Ancona Manuel D'instructions page 6

o
o
o
FM radio information
When a radio station is playing, press the <Info> button repeatedly to cycle through the information broadcasted by the radio
as follows:
• RT (Radio text): Text broadcasted from the FM station (if available).
• Signal error: The signal strength is displayed graphically.
• Time/Date: The time and date are set automatically.
• Frequency: The FM frequency for the radio station in playing.
• Auto / Stereo: Automatic switching between mono and stereo reception.
Note: The time and date accuracy depends on the info broadcasted from the radio station.
If you would like to save a station not on the preset list or replace a preset station with another one, select the desired station
to play first. Then press and hold down the <Preset> knob, entering the "Preset Store" list. If a preset save slot is available, it
will show "Empty". Or choose the number you would like to replace by rotating the <Tuning/Enter> knob. To store the station
as preset, press the <Tuning/Enter> knob, "Preset x stored" will show on the display. To recall the preset station, simply press
the <Preset> knob briefly, rotate the <Tuning/Enter> knob to navigate and press the <Tuning/Enter> a final time to confirm.
There are 40 presets available for DAB and 40 presets for FM.
Before transmission between your BT device and the radio is possible, both devices must be coupled. This process is called
"pairing". The radio is served as a receiver, to receive music stream to play on the radio.
•
Press the <Mode> button to cycle through the different operating modes, ultimately selecting BT mode.
•
Switch on your BT device to which you want to connect the radio to and activate the pairing mode. The device scans
for BT devices within the reception range.
•
When the radio is found, your BT device shows its name "Audizio Ancona".
•
Select the radio on your BT device. If the pairing is successful, "Connected" will appear on the display.
•
Start playback on your BT device.
•
Playback now takes place using the radio. Rotate the <Tuning/Enter> knob to skip tracks. Press the <Tuning/Enter>
knob to pause/play.
•
Insert a USB flash drive in the USB port on the back of the device.
•
Press the <Mode> button to cycle through the different operating modes, ultimately selecting USB mode.
•
The radio will start reading and playing the flash drive automatically.
•
Rotate the <Tuning/Enter> knob to skip tracks. Press the <Tuning/Enter> knob to pause/play.
Language
Choose between multiple available languages.
Factory reset
By selecting this option, use <Tuning/Enter> rotary knob to choose "YES" and press down
<Tuning/Enter> to confirm, the radio will reboot and all settings will be resumed factory's default
(all previous settings/presets will be erased).
SW version
Enter to show the current software version.
6