Audizio Ancona Manuel D'instructions page 5

Tune DAB station
After the scan is done, rotating the <Tuning/Enter> knob will enter into the station list. Select the station you want to listen
to and press the <Tuning/Enter> knob to confirm. The station will start to play.
DAB main menu
There are other options available under DAB mode. Press the <Menu> button, entering into the menu as follows.
Note: always rotate the <Tuning/Enter> button to select and press down <Tuning/Enter> to confirm a selection. Use the
<Menu> button to exit to the last menu.
•
Full scan
The radio will pick up the DAB stations available in your area.
•
Manual tune
This function allows you to check whether a specific frequency can be received in your area and display it's
signal strength. When this option is selected, it will show a list of DAB frequencies. Choose the desired
frequency and it will display the signal strength.
•
Prune
Choose "Yes" on this option to delete the DAB stations from your list that are no longer valid or stopped
service.
•
System
o
o
o
o
DAB radio information
When a radio station is playing, press the <Info> button repeatedly to cycle through the information broadcasted by the radio
as follows:
• DLS (Dynamic Label Segmenting): Radio text broadcasted from the DAB station such as the news, songs being played, etc. if
available. If no such information is available, the display will just show "playing".
• PTY (Programme Type): Shows which type of programme you are listening to, "Music", "Talk", "News" etc. If there is no
information, it will display "Programme Type".
• Channel/Frequency: The frequency of DAB is displayed such as "11C 220.352MHz".
• Audio info: The display shows the digital audio bit rate of the current reception.
• Signal error: The signal strength is displayed graphically.
• Time/Date: The time and date are set automatically.
Note: The time and date accuracy depends on the info broadcasted from the radio station.
FM scan
Press the <Mode> button to switch to FM. Press the <Scan> button to enable the Auto Scan function. The device will scan the
available stations according to the scan settings selected in the options menu and store stations in the preset list
automatically (see below section for scan setting). To scan manually, rotate the <Tuning/Enter> knob and it will fine tune the
frequency with steps of 0.05MHz.
•
Scan setting
There are two types of scan available. The scan is carried out according to "Strong station" or "All station". If
"Strong station" is selected, it will scan only the channels with strong reception signal where the radio is
placed. If "All station" is selected, it will scan out both the strong and weak channels.
•
Audio setting
You can choose to have "Forced Mono" or "Stereo allowed". If the signal is weak and stable stereo reception
is not possible, select "Forced Mono" have better reception.
•
System
o
Sleep
Set the sleep timer to switch off the radio after a certain time has elapsed. The timer will be
displayed in the top right corner of the display. If 15 minutes is set, it will display S15. If you wish
to cancel the sleep timer, choose "OFF" from the options and press <Tuning/Enter> to confirm.
Language
Choose between multiple available languages.
Factory reset
By selecting this option, use <Tuning/Enter> rotary knob to choose "YES" and press down
<Tuning/Enter> to confirm, the radio will reboot and all settings will be resumed factory's default
(all previous settings/presets will be erased).
SW version
Enter to show the current software version.
Sleep
Set the sleep timer to switch off the radio after a certain time has elapsed. The timer will be
displayed in the top right corner of the display. If 15 minutes is set, it will display S15. If you wish
to cancel the sleep timer, choose "OFF" from the options and press <Tuning/Enter> to confirm.
5