Audizio Ancona Manuel D'instructions page 4

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts
are present, and have been received in good condition. Notify the shipper immediately and retain packing material for
inspection if any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and
all packing materials. In the event that the product must be returned to the factory, it is important that the product be
returned in the original factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately.
The arising condensation water might damage your device. Leave the device switched off until it has reached room
temperature.
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the
mains voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product
must also be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
1. Volume control
Rotate to adjust the volume.
2. Tuning/Enter knob
Rotate to tune, scroll, etc. Press to confirm your inputs.
3. On/Off button
Press and hold to power on the device. Press to power
off.
4. Mode
Press repeatedly to cycle through various modes.
5. Preset
Press and hold to enter the "Preset store" list. Press to
enter the "Preset recall" list.
6. Info
Press repeatedly to cycle through various radio station
info.
7. Scan
Initiate auto scan function in DAB or FM mode. Received stations will be stored as preset automatically.
8. Menu
Press to enter the main menu. Use the <Tuning/Enter> knob to navigate within the main- (and sub-) menus.
9. DC 5V
USB-C port to connect the supplied power cable.
10. USB port
11. Headphone jack
3.5mm headphones output jack.
12. Antenna
The radio is powered by the built-in lithium battery. A USB-C type cable is supplied in the product package. Press and hold
the <Power on/off> button to power on. To power off the radio, press the same button briefly.
You can check the battery power level on the radio with the battery indicator in the top right corner of the display. When
battery power is low, "Battery Low" will appear on the display to inform you. To charge the battery, connect the USB-C plug to
the port on the back of the radio, connect the other end to a power source supplied with 5V OUT. The LED will light up in red,
indicating the battery is charging. If the radio is OFF while charging, the LED will go off when charging is finished. If the radio is
ON when charging, the LED remains red even when charging is completed. Please check the battery indicator to see the
charging status.
DAB scan
The first time you power on the radio, it will scan the DAB radio stations automatically. It will display and play the first station
after the scan is done. In case it displays "DAB No Station!", pressing the <Scan> button will initiate the Full scan of the DAB
stations.
4