Setting The Unit; Gain Control; Input Select Switch; Cut Off Frequency Control - Pioneer GM-6000F Mode D'emploi

Setting the Unit

Gain Control

Adjusting the gain controls A and B will
help match the output of the car stereo
to the Pioneer amplifier. Normally, set
the gain controls to the "NORMAL"
position. If the output is low, even when
the volume of the car stereo is turned
up, turn these controls clockwise. If
there is distortion when the volume of
the car stereo is turned up, turn these
controls counter-clockwise.
• If you only use one input plug, set the gain
controls for speaker outputs A and B to the
same position.
• When using with an RCA equipped car
stereo (standard output of 500 mV), set to
the NORMAL position. When using with
an RCA equipped Pioneer car stereo with
max. output of 4 V or more, adjust level to
match the car stereo output level.

Input Select Switch

For two-channel input, slide this switch
to the left. For four-channel input, slide
this switch to the right.
3
All manuals and user guides at all-guides.com

Cut Off Frequency Control

If the LPF/HPF select switch is set to
LPF or HPF, you can select a cut off
frequency from 40 to 120 Hz.