Ham EWS-830 Mode D'emploi page 7

6.2. Connection to the measuring station
• After making initial settings, the base station automatically searches for a connection to the measuring
station and performs initial setup.
Note
• Initial setup takes approx. 3 minutes.
• During connection, the wireless symbol on the measuring station will flash (29).
• Do not press any buttons during setup. Otherwise, values may not be transmitted correctly and there is a
risk of value errors and inaccuracies.
• The setup process is completed when the indoor (6, 10) and outdoor (22, 28) measurement data is
displayed.
• If the base station still does not receive a signal from the measuring station, press and hold the CHANNEL
button (39) for approx. 3 seconds to start the manual search for the signal.
6.3. Selecting the channel/other measuring stations
Note
You can install two more measuring stations in addition to the included measuring station. Ensure that the
base and measuring stations are set to the same channel.
Visit www.hama.com for suitable measuring stations.
• Press the CHANNEL button (39) repeatedly to set the channel to that set on the respective measuring
station – see 4.1. Measuring station . 1, 2, 3 (30) or Channel overview (24) is displayed.
• The base station now shows the data measured (22, 28) on the selected measuring station (30).
• Select Channel overview (24) to show the measurement values of the individual measuring stations/
channels consecutively for 5 seconds each.
6
All manuals and user guides at all-guides.com