Caractéristiques techniques
Tension de fonctionnement
Courant de charge
Tension finale de charge 1,2V (Pb) : 2,45V pour accu 2V (douilles
Témoin de charge
Température de travail
Dimensions (larg. x haut. x prof.)
Connexion au réseau
34
All manuals and user guides at all-guides.com
: Tension alternative 230V, 50 Hz
: 25 – 60 – 100 – 150 – 180 –
200 – 700 mA ± 10% max. 10
cellules chacun
de bougies de préchauffage)
7,35V pour accu 6V (accus de
conduite)
14,7V pour accu 12V (accus
de conduite)
: Témoin LED allumé rouge au-
dessus de chaque sortie
Témoin LED allumé vert com-
me témoin de fonctionnement
: De 0º C à + 40º C, humidité
de l'air relative < 75% non
condensante
: Environ 195 x 115 x 125 mm
(sans câble de raccordement,
poignée, enrouleur de câbles
: Fiche de contact norme euro-
péenne, bipolaire sans conduc-
teur de terre, env. 1,5 m.
Prescribed Use:
- Charging four (4) to ten (10) cells (1.2 V each) of NiCd or NiMH
with a capacity of 120 mAh to 8000 mAh with different charging
currents (can be plugged in parallel).
- Charging one (1) to six (6) cells (2 V each) lead-acid or lead gel up
to 8 Ah.
- According to the standard VDE 0510, non-rechargeable batteries
(zinc-carbon, alkaline etc.) must not be charged.
- The Duo – Tech Battery Charger may only be connected and
operated at 230 V AC.
Do not use the product in wet rooms or outdoors, or under adverse
environmental conditions. Adverse environmental conditions are:
- dampness or high humidity
- dust or inflammable gases, vapours or solvents
- strong vibrations
Any other application than the one described above damages the
product. Moreover, this involves dangers, such as e.g. short-circuit,
fire, electric shock, etc. No part of the product may be modified or
rebuilt. Observe the safety instructions and technical data.
Control Elements
Illustration (fold-out page)
1
Two-pin Euro mains plug, without ground contact for 230 V AC
operation.
2
Outputs: 4 mm sockets plus (+) and minus (-) for connecting
the battery packs.
3a Charging current selector switch for output 1 (from the left) 25
or 60 mA,
15