Antec SP1 Manuel D'utilisation page 3

Answer/End Calls
Press the center button to answer and end calls.
To Make a Call
Use your phone to dial. Your SP1 will then function as a speakerphone.
Troubleshooting
The device is malfunctioning
• Always check for proper charge and make sure that the device is On
The device is creating distortion or the sound quality is poor
• Lower the volume on the SP1 and increase the volume on your phone
or device
• Connect the SP1 directly to your device using the 3.5 mm cable
• Check the charge of the SP1 and your mobile audio device and recharge
if necessary
• Re-pair the devices using the instructions listed under the "Pairing
Mode" section
The SP1 fails to pair with Bluetooth enabled device
• Confirm that your device is Bluetooth compatible and that the Bluetooth
setting is enabled
• Re-pair the devices following the instructions listed under the "Pairing
Mode" section
The signal drops or connection fails in Bluetooth mode
• Move the SP1 closer to your mobile device
EN
• Ensure the SP1 is fully charged
• Turn off the SP1, wait one minute, power it back on and reconnect to the
Bluetooth-enabled device using the instructions listed under the "Pairing
Mode" section
Notice: Avoid placing SP1 near the edge of surfaces since it may shift
during use and fall over. Warranty does not cover physical damages as a
result of such falls and other mishaps.
EN