Antec SP1 Manuel D'utilisation page 2

Getting Started
Please fully charge SP1 before initial use. Connect the included
Micro-USB cable to your SP1 and a USB slot of any PC or Mac to
charge. The RED LED will turn on while charging and will turn off
when fully charged.
Pairing Mode
Push and hold the center button for 6-8 seconds until the LED
constantly flashes white. You are now in Pairing Mode. See your
phone/music device manual for pairing instructions.
Volume down
EN
Center Button
Volume up
LED Indicator
LED Color
Flashing Red
Alternating Red and White
Solid White
Flashing White
Connections
You may connect to your device wirelessly via Bluetooth or use a 3.5
mm stereo input cable.
Start Listening
For optimal sound, place SP1 on its base (with the a.m.p. label on the
bottom) and faced towards you (with the SP1 label read from left to right).
When connected via Bluetooth, it's best to have the phone volume
turned fully up and use the "+" and "-" buttons that are located on the
top of your SP1.
If you decide to use the 3.5 mm function, please make sure that the
SP1's volume is turned down before operation. This will reduce the
tendency to overdrive the speaker's units causing distortion to the audio.
Socializing
The SP1 can be used as a wireless speakerphone. The built-in
microphone will only function under wireless connectivity via Bluetooth.
Description
Low Battery
Charging
Fully Charged
Pairing Mode
EN