Alarm Time Setting; Radio Operation - Proline CR75P Manuel D'utilisation

All manuals and user guides at all-guides.com
SETTING THE MAIN CLOCK
NOTE: There are two separate clocks in this product.
1. Set the Power Selector (11) to"OFF". Connect the mains lead to the power supply. The
base clock display will flash on and off indicating a power interruption and that the
displayed time is incorrect. Please note, the projection clock does not flash after a
power interruption!
2. To set the correct time, press and hold the Time Set Button (7) then press the Hour Set
Button (10), or Minute Set Button (9), together, until the correct time is displayed. (Release
all buttons)
3. Open the clock Battery Door (14) on the under side of the unit and insert a 6LR61 (or
equivalent) 9-volt battery. The purpose of this battery is to store the information relating to
alarm time and to keep the clock functioning in the event of disconnection from the mains
supply or power interruption. Should this occur, the clock would continue to keep time, but
the display will not illuminate.
PLEASE NOTE: When operating from battery, the clock will only remain accurate for a short
period of time. It is important that the mains supply is restored as soon as possible.

ALARM TIME SETTING

1. Press and hold the Alarm Set Button (6) and repeatedly press the Hour Set Button (10)
then the Minute Set Button (9) as appropriate until the required alarm time is displayed.
(release all buttons)
2. To double check the alarm time, simply press the Alarm Set Button (6) then the display will
show the pre-set alarm time.

RADIO OPERATION

For AM reception this unit uses an internal directional aerial, rotate the unit for best reception.
For FM reception, the wire FM Antenna (12) on the back of the unit should be fully unwound.
1. Set the Power Selector (11) to the "ON" position.
2. Set the Waveband Selector (4) to the required waveband. (AM or FM )
3. Use the Tuning Control (3) to select the desired station.
4. Adjust the Volume Control (2) to the desired listening level.
5. To turn off the radio, set the Power Selector (11) to"OFF". If the radio does not switch off
this may be caused by inadvertent operation of the Sleep Set Button (8). To cancel this,
press the Snooze Button (5) once.
WAKE TO RADIO
Having selected your desired station and adjusted the desired listening level proceed as
follows: -
1. Follow the instructions for "ALARM TIME SETTING" above.
2. When the desired alarm time has been set, set the Power Selector (11) on the "AUTO"
position.
ENGLISH 4