Honeywell Lyric C1 Mode D'emploi page 3

Connect
Connect to mobile device
1 Enable bluetooth on your mobile device.
2
The app will look for the camera.
• For one camera, it will connect
automatically.
• For more than one camera, the app will
prompt you to select one camera at a
time. Each camera has a unique MAC ID
printed on the back. Use that ID to select
the camera you want to connect.
3 A QR code will display in the app. To
connect your camera to the app, hold the
QR code approximately 3-8 inches (7-
20 cm) from the camera lens.
4 The camera LED turns purple and the
camera beeps.
Connect to Wi-Fi
Note: Be sure you are on the same Wi-Fi
network you wish to connect your camera to.
1 Choose your Wi-Fi network from the list.
Tap NEXT.
2 Enter your Wi-Fi password, if necessary.
Tap DONE.
Note: The camera will beep during some steps
in this process.
Connect
Looking for Camera
3
Carrier 8:08 AM 100%
Connect
Scan code to connect camera
2.7-7.9 in
NEXT