UK
Cleaning the Inside of the Appliance
After 100 hours of use BUFFALO recommend that the inside of the glass and the reflector is cleaned with
a lint-free cloth.
To clean the interior:
Switch off the appliance, disconnect the power supply and allow to cool.
1.
Loosen the two screws above the glass panel.
2.
Swing the glass panel down.
3.
Carefully wipe the element, glass panel and reflective surfaces clean with a lint-free cloth.
4.
Replace the Halogen Element
Switch off the appliance, disconnect the power supply and allow to cool.
1.
Unscrew the two screws above the glass panel.
2.
Swing the glass panel down.
3.
Lift the element from the sockets, one end at a time.
4.
Replace the new element; slotting it into place.
5.
Note: DO NOT touch the surface of the new element with your bare hands! Use a dry lint-
free cloth or suitable gloves.
Re-attach the glass panel; ensuring it is clean.
6.
Secure with the two screws. Tighten fully to ensure a water tight seal.
7.
Troubleshooting
If your BUFFALO appliance develops a fault, please check the following table before making a call to the
Helpline.
Fault
The appliance is not working
Steam build up on the inside of the
glass
Technical Specifications
Model
Voltage
CC036
230V 50Hz
3
All manuals and user guides at all-guides.com
Probable Cause
The appliance is not switched on Check the appliance is plugged in correctly
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Glass panel screws are not fully
tightened
Power
Current
1200W
5.2A
and switched on
Call BUFFALO agent or qualified technician
Replace the plug fuse
Check power supply
Call BUFFALO agent or qualified technician
Disconnect from power supply and allow to
cool.
Release glass panel and wipe clean with a dry
lint free cloth.
Replace glass panel and tighten screws fully
Dimensions h x w x d (mm)
250 x 345 x 170
Action
Weight (kg)
2.6kg