Danfoss AS Serie Guide D'installation

Installation guide
Solenoid coil
Types AS, AU, and AZ
© Danfoss | DCS (rja) | 2015-12
50 − 60 Ncm (0.39
40 − 50 Ncm PG 11
(0.30 0.39 lb-ft) 250
−
(1.84
Max. 8 mm (0.31 in)
Min. 4 mm (0.16 in)
AS
Plug
AU
Cable
AS / AZ
Spade
− 0.44 lb-ft)
r > 55 mm (2.16 in)
375 Ncm
−
− 2.77 lb-ft)
Cable strain relief
ENGLISH
Type of control 1
Safety classification Class I
Ambient temperature 6 W V AC NC valve
7 W V AC NC valve
14 W V DC
0 − 100% R.H. (0 − 97% R.H. non-condensation
Humidity
condition if IP level is below IPX5)
-15% − 10%
Voltage variation V AC
V DC ±10%
Ball pressure test 200 °C (392 °F)
Impulse withstand voltage Cable 4.0 kV at altitude <4000 m (13123 ft)
Spade 4.0 kV at altitude <4000 m (13123 ft)
Plug 4.0 kV at altitude <2000 m (6561 ft)
Plug 3.1 kV 2000 m<altitude<4000 m
(6561<altitude<13123 ft)
Enclosure rate IPXX Cable IP67
Pollution degree PDX Plug IP65
Spades IP00
Installation Integrated control
Incorporated control
Independently mounted control
ø6.6 − ø11 mm (ø0.26 − ø0.43 in)
Suitable cable and
0.75 − 1.5 mm² (21 − 15 AWG flexible cord)
conductor size for plug
Number of mating for plug 10 times
Cable size ø6.6 mm (ø0.26 in)
Cable conductor size 3 x 0.75 mm² (3 x 0.001 in
Installation and handling for cable: > 5 °C (41 °F)
- Only qualified personnel is allowed to install or maintain this product.
- Disconnect the power when dismounting the coil.
- Ensure that the O-ring is in place on the valve.
- If the coil is used as independently mounted control, the end-user shall use a
plastic cable gland with strain relief.
-40 − 60 °C (-40 − 140 °F)
-40 − 50 °C (-40 − 122 °F)
-40 − 60 °C (-40 − 140 °F)
PD4
PD3
PD3
2 )
DKRCC.PI.BU0.A1.2T | 1