Publicité
Les langues disponibles
Les langues disponibles
Using your Ceramic Hob (F1)
1.
Double ring control
2.
Regulator
3.
ON/OFF
4.
Zone selector
To start cooking
1.
Touch the ON/OFF (3) for 3 seconds. After power on, the buzzer beeps once, all
displays show "0", indicating that the ceramic hob has entered the state of standby
mode.
2.
Place a suitable cookware on the cooking zone that you wish to use. Make sure
the bottom of the cookware and the surface of the cooking zone are clean and dry.
3.
According to the cooking zone where the cookware is placed, press the desired
zone selector (4).The symbol "0." selected will flash.
4.
Select the power level by pressing the "+"or "-" of the regulator (2)
5.
The power level will start at 0. Pressing the "+" will count up the power levels from
0 to 9 in numerical order. Pressing the "-" will take the power straight from 0 to 9.
• If you don't set the power within 30 seconds, the ceramic hob will automatically
switch off. You will need to start again at step 1.
• You can modify the power setting at any time during cooking.
When you have finished cooking
1.
Touch the relevant zone selector (4) that you wish to switch off.
2.
Press "-" of the regulator and the power will decrease to "0" level, or press the
"+" and "-" at the same time and the power level will decrease to 0 straight away.
3.
Beware of hot surfaces
After switching off the cooking zone, the corresponding power display will indicate "H"
until the temperature in the zone has dropped below the critical level. It will disappear
EN
Publicité
